This tool allows you to flash an ESP32 with the IoTy firmware.
This will connect to your ESP32 via Web Serial.
Hides the non-ESP32 devices, but some valid ESP32 devices may not appear.
Show all devices, but may be hard to identify the correct device.
Click one of the following to load a micropython before continuing. If your device is already flashed with a suitable micropython, you can skip this step.
Not LoadedBaudrate: Flashing micropython will erase everything on the device.
After clicking the above button, if the "Connecting..." message takes more than a couple of seconds, press and hold the boot button on your ESP32 until the chip is detected.
If errors occurs, try again with a lower baudrate (...seems commonly required on Mac).
This will copy the IoTy firmware to your ESP32.
Device name: Cannot be empty and max of 8 characters.